Pure Copper Motor Humanized Clutch Traffic Barrier Gate Aluminum
Suitable for indoor as well as outdoor parking area
Parking lots, toll gate, goods yard, railway crossing, commercial
premises, apartment block access shopping malls, hospitals,
stadiums, business centers,etc.
Functions and Features
1. Mould production with accurate grinding and heat treatment of
worm and main rod, which is high accuracy, low comsumption and less
2. Arm Reverse Function: Arm will be automatically reverse when it
hits obstacles when closing.
3. Arm Swing Out Function: Arm will be swing out when vehicle hits
the arm which can avoid further damage to the vehicle.
4. Cooling Fan Device: It will be automatically opened when the
motor works in heavy duty and high temperature.
5. Manual Release Cluntch: When loss of power, it can manually open
and close the barrier.
6. Sturdy Housing: 2mm thickness cold roll plate or galvanized
plate with expoxy paiting, which can be heavy duty.
7. Anti-freezen oil can make our barrier gate working in -45
8. Spring sleeve can protect the accessories inside the machine
case from damaging by spring broken.
9. Module production with all accessories, can be replced easily,
and save cost.
10. Pressure spring can avoid damage casued by tention spring,
which is more safety.
Motor Speed and Boom Type:
|Boom type||Boom Length(M)||Opening time(S)||Height between boom and ground(M)|
1. Drive Motor is warranted against manufacturer’s defect for
2. Standard warranty for all components is valid for12 months from
the date of delivery
3. This warranty does not include damages caused by:
a. Wear and Tear
d. Act of God & Natural Disaster
e. Unstable power supply (i.e. inconsistent voltage or lightning)
1. When barrier finish closing, why does the arm open itself
the spring is too tight, you need release the spring a little, then
test it again.
see whether the main crank touch the triangle tightly or not, if
tightly, adjust it.
reset the balance position and the electrical limit switch.
2. Why does the controller panel operate with "Di Di Di" abnormal
As for this, it means the resistance on controller board is broken,
if you have professional tools to check,
then replace that broken resistance, if not, replace that
3. Why does the barrier finish half operation of opening and
If uses our controller panel, you only need to find resistance R37
on controller panel, and repalce it is ok.
4. When barrier closed, why is there a 5 degree angle of
the model is not good, and the gear doesn't fit each other tightly.
the barrier didn't adjust well, need to reset.
5. When barrier finish open, but it closes itself without any order
control, what's the problem?
To check the loop cable first, because the loop cable maybe brokem
To check the motor sensor, if it is not set well, then reset it in
the middle between two holes on sensor rod.
6. Why does the arm wave a lot when opening and closing?
The spring is very tight
The Screw touches the rubber absorption tightly, need to reset
7. Rubber linning installation suggestion:
It is good use for fast speed, like 0.6s, 1s, 1.8s and 3s.
The place with many vehicles come and go, like shopping center,
8. Can you accept OEM/ODM order?
Absolutely, we are manufacturer of barrier gate, with 7 years
researching and developing experience.
Contact us for pricelist and catalog: