Customized Swing Out Barrier Gate Operator With 6M Straight Arm
And other places with heavy traffic flow
|Voltage||220V±10%, 110V±10%, 50/60HZ|
|Remote control distance||≥30m|
|Max boom length||5meters|
1. Manual release device to operate the barrier when power failure
2. Barrier motor with die-casting aluminum alloy is high-hermetic
easy for heat dissipation
3. Motor cooling fan to avoid the over-heating possibility
4. Automatic reversing when the barrier boom meets the obstruction
5. Auto closing realization through menu setting on the control
6. The barrier works well with infrared photocells, loop detectors,
card readers, ticket dispensers, manual switch (wire control), and
7. RS485 Communication Module is compatible
8.Special art and craft makes out the most modernized and
9.Safety photo electricity limit switch
10. Auto warming-up, suitable for cold environment
11. Boom with LED light (color is changeable with remote control)
Warranty:Our Service :
1. Drive Motor is warranted against manufacturer’s defect for
2. Standard warranty for all components is valid for12 months from
the date of delivery
3. This warranty does not include damages caused by:
a. Wear and Tear
d. Act of God & Natural Disaster
e. Unstable power supply (i.e. inconsistent voltage or lightning)
1. Our Factory has 8 years OEM/ODM experiences in the line of
barrier gate .
2. Prompt delivery time. Usually we keep stock of standard model
which ensure the prompt delivery.
3. We accept OEM/ODM orders to meet the requirements of clients.
4. Trial order is acceptable. Clients can buy sample and test it
before bulk order.
5. Online technical support makes it carefree to be our business
6. A variety of transportation for your choice. Sea shipment, air
cargo or express, depends on your demand.
7. Factory can be visited on working days. Clients are warmly
welcome to visit our factory.FAQ:1. When barrier finish closing, why does the arm open itself
- the spring is too tight, you need release the spring a little, then
test it again.
- see whether the main crank touch the triangle tightly or not, if
tightly, adjust it.
- reset the balance position and the electrical limit switch.
2. Why does the controller panel operate with "Di Di Di" abnormal
- As for this, it means the resistance on controller board is broken,
if you have professional tools to check,
- then replace that broken resistance, if not, replace that
3. Why does the barrier finish half operation of opening and
- If uses our controller panel, you only need to find resistance R37
on controller panel, and repalce it is ok.
4. When barrier closed, why is there a 5 degree angle of
- the model is not good, and the gear doesn't fit each other tightly.
- the barrier didn't adjust well, need to reset.
5. When barrier finish open, but it closes itself without any order
control, what's the problem?
- To check the loop cable first, because the loop cable maybe brokem
- To check the motor sensor, if it is not set well, then reset it in
the middle between two holes on sensor rod.
6. Why does the arm wave a lot when opening and closing?
- The spring is very tight
- The Screw touches the rubber absorption tightly, need to reset
7. Rubber linning installation suggestion:
- It is good use for fast speed, like 0.6s, 1s, 1.8s and 3s.
- The place with many vehicles come and go, like shopping center,
8. Can you accept OEM/ODM order?
- Absolutely, we are manufacturer of barrier gate, with 7 years
researching and developing experience.
Contact us for pricelist and catalog: